Applies to ProTool/Pro CS version 5.2 or higher plus Service Pack 3 User Manual ProTool V6.0 Service Pack 2 How to configure Windows-based systems 6AV6594-1MA06-1AB0 iĤ Preface Release 12/02 Release 12/01 Release 12/02 Valid for ProTool CS 6.0 or higher. Applies to ProTool/Pro CS version 5.2 or higher plus Service Pack 2 Incorporation of MP 370 and SIMOTION PLC drivers. Extensions, new operating units and new PLC drivers.
Software runs under Windows 95/98, Windows 2000 and Windows NT 4.0 and higher. Extensions and inclusions of new operating units. Software runs under Windows 95, Windows 98, Windows NT 4.0 and higher. Inclusion of MP 270 and editorial reworking of manual. The various issues of the documentation correspond to the following product versions: Release 07/98 Release 01/99 Release 12/99 Release 07/00 Release 03/01 Configuring Windows-based systems. History of the documentation This documentation describes the configuration of Windows-based systems with ProTool. The complete route to the menu option in question is always shown. Successive submenus/options are separated by arrows. Notation Different font formats simplify orientation within the text: Output File > Edit Names of dialog boxes, fields and buttons are shown in quotation marks. It provides all information required for the creation and configuration of projects. Siemens AG 2002 Technical data subject to change.ģ Release 12/02 Preface 1 Preface Purpose This document forms part of the documentation package for the ProTool CS configuration software. We would be grateful for any suggestions for improvement. The information in this publication is checked regularly, and any necessary corrections are included in the following editions. However, discrepancies cannot be excluded, with the result that we assume no guarantee for total compliance. Siemens AG Bereich Automation & Drives Geschäftsgebiet SIMATIC HMI Postfach 4848, D Nuernberg Siemens Aktiengesellschaft Exclusion of liability We have checked the content of this publication for compliance with the described hard and software.
All rights reserved, especially in the case of the granting of a patent or registration by GM. Impressum Editor and Publisher: A&D PT1 Copyright Siemens AG 2002 All rights reserved The transmission and reproduction of this documentation and the exploitation and communication of its contents are not allowed, unless expressly granted. Trademarks The registered trademarks of the Siemens AG can be found in the preface. Qualified personnel within the meaning of the safety notices of this documentation are persons capable of giving due consideration to safety engineering standards when using this software on systems.
Qualified Personnel Only qualified personnel should be allowed to install and work with this software. Note draws your attention to particularly important information on the product, handling the product, or to a particular part of the documentation. Attention indicates that unwanted events or status can occur if the relevant information is not observed. Caution used without safety alert symbol indicates a potentially hazardous situation which, if not avoided, may. Caution used with the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. Warning indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. These notices are marked as follows according to the level of danger: Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
1 SIMATIC HMI ProTool V6.0 Service Pack 2 How to configure Windowsbased systems User Manual Preface, Contents Introducing ProTool 1 Getting started in ProTool 2 ProTool integrated in SIMATIC STEP 7 3 Creating and editing projects 4 Configuration techniques 5 Testing projects 6 Documenting and managing projects 7 Appendix, Index Order number 6AV6594-1MA06-1AB0 Release 12/02 A5EĢ Safety Guidelines This manual contains notices which you should observe to ensure your own personal safety, as well as to protect the product and connected equipment.